ABB IRB 8700 Series Product Manual page 213

5
6
7
Removing the SMB/BU cables
1
2
Product manual - IRB 8700
3HAC052853-001 Revision: F
Action
Carefully pull the SMB unit out a little and disconnect
the connectors from the SMB board:
• R1.SMB1-3, R1.SMB4-6 and R2.SMB
• Battery cable connector R2.G.
Disconnect the battery cable by pressing down
the upper lip of the R2.G connector to release
the lock while pulling the connector upwards.
Use caution and remove the SMB unit.
Keep the SMB unit in an ESD bag until it shall be re-
fitted.
Action
DANGER
Make sure that all supplies for electrical power, hy-
draulic pressure, and air pressure are turned off.
ELECTROSTATIC DISCHARGE (ESD)
The unit is sensitive to ESD. Before handling the unit
please read the safety information in the section
unit is sensitive to ESD on page 32
© Copyright 2015-2018 ABB. All rights reserved.
4.4.1 Removing the cable harness
Note
xx1300000728
xx1700000993
xx1300000731
ESD bag
Note
The
Continues on next page
4 Repair
Continued
213