Suzuki GA413 Service Manual page 635

Rear Door
Terminal
RIGHT SIDE Door RIGHT SIDE Door
LEFT SIDE Door LEFT SIDE Door
REAR DOOR JUNCTION SWITCH
INSPECTION
1) Disconnect negative (–) cable at battery.
2) Remove door trim and center pillar lower trim as necessary.
3) Disconnect body side coupler and door side coupler of rear door
junction switch.
4) Close rear door.
5) As shown in the figure, check that there is continuity between
terminals of the same wire color.
If not, replace junction switch.
STOP LAMP SWITCH
INSPECTION
Use an ohmmeter to check switch for continuity.
If found defective, replace switch.
Switch slider pushed ON
Switch slider released OFF
BODY ELECTRICAL SYSTEM 8-33
Operation
UNLOCK
*
M1
)
M2
)
M1
*
M2
No continuity
Continuity
LOCK
)
*
*
)