Suzuki GA413 Service Manual page 645

1. Cloth
2. Regulator handle
1. Glass attaching screw
1. Attaching nut
2. Window regulator
3. Attaching bolt
1. Cloth
2. Inside handle
2. Door glass
REAR DOOR GLASS AND WINDOW REG-
ULATOR
REMOVAL
1) Remove inside handle. For its removal, pull off snap by using
a cloth as shown in figure.
2) Remove inside lock knob.
3) Lower glass fully and remove outer weatherstrip.
4) Remove window regulator handle (refer to FRONT DOOR
GLASS REMOVAL).
5) Remove door trim and inner weather strip (if equipped).
6) Remove door sealing cover.
7) Remove door sash.
8) Remove glass run.
9) Remove glass attaching screws.
10) Take out door glass.
NOTE:
Be careful not to damage to the glass.
11) Remove window regulator attaching nuts and bolts (six pcs.).
Then, take out regulator through hole "A".
INSPECTION
1) Check regulator sliding and rotating parts for greasing.
2) Check rollers for wear and damage.
3) Check wire for damage.
BODY SERVICE 9-9