Suzuki GA413 Service Manual page 544

GEAR SHIFT CONTROL LEVER AND CABLE
REMOVAL
1) Remove T/M control cable end clips and washers.
2) Remove cable cap clips.
3) Remove T/M control cable from control cable bracket.
4) Remove console box and then control cable grommet plate.
5) Remove gear shift & select control cables from gear shift control
lever assembly.
6) Loosen 4 bolts and take out gear shift control lever assembly.
INSTALLATION
1) Apply grease to turning or sliding portions.
2) If knob has been removed from lever, apply thread lock cement
and then install knob to control lever. Make sure that knob is
aligned with lever.
3) Install control lever assembly and related parts as they were.
NOTE:
D Make sure that boots are installed correctly.
D Check control lever for smooth movement after assem-
bly.
MANUAL TRANSMISSION 7A-5
1. Shift control knob
2. Boot
3. Spacer
4. Cushion
5. Shift control cable assembly
6. Select control cable assembly
7. Control cable bracket
8. Grommet
9. Grommet plate
10. Washer
11. Clip
12. Clip
13. Gear shift control lever assembly
14. Cable cap clip