Suzuki GA413 Service Manual page 648

9-12 BODY SERVICE
Weather strip end set position
"a": 115 " 20 mm
1. Lower arm
2. Bolt
3. Door stopper
INSTALLATION
Reverse the removal sequence to install rear door.
NOTE:
When replacing door, coat replacement door inside with wax
for proper anticorrosion treatment.
Refer to RUST PROOF TREATMENT AREA in this section.
D When weatherstrip is hardened, water leak may develop. In this
case, replace it if possible.
D After installing, adjust door fitting and door latch striker position
as described below and apply grease to greasing point.
D For correct installation of door, refer to PANEL CLEARANCE of
this section.
Door fitting adjustment
1) Unfix rear door stoppers by loosening screws.
2) Adjust lower arm so that door front surface and body surface
align each other with the door closed.
1. Upper arm
2. Slide hinge
3. Lower arm
4. Door stopper
5. Shim
6. Door open stopper
7. Door rail