Suzuki GA413 Service Manual page 1107

D For AXC externally mounted type:
Install output shaft rear bearing (1) by using hydraulic press and
special tool.
Special Tool
(A): 09940-53111
D For AXC built-in type:
Apply transmission oil to sprocket needle bearing, then install out-
put sprocket bush (1), sprocket needle bearing (2) output front
sprocket (3) and output front sprocket washer (4).
D Tighten new output front shaft nut by using special tool.
Tightening Torque
.
(a): 125 N m (12.5 kg-m, 90.5 lb-ft)
Special Tool
(A): 09930-40113
D After cleaning mating surfaces of transmission case and transfer
front case (1), coat mating surface of front case with sealant even-
ly and put it over transmission case.
"A": Sealant 99000-31110
D Apply sealant to 2 bolts (1) as shown in figure and then tighten
front case bolts to specified torque.
"A": Sealant 99000-31110
Tightening Torque
.
(a): 23 N m (2.3 kg-m, 16.5 lb-ft)
MANUAL TRANSMISSION (4WD) 7A1-13