Suzuki GA413 Service Manual page 240

5-44 BRAKES
3) Apply grease to axle shaft oil seal lip as shown.
4) Apply sealant to mating surface of axle housing with brake
1. Oil seal
2. Axle housing
5) Install rear axle shaft to rear axle housing.
6) Tighten brake back plate bolts to specified torque.
7) Install wheel cylinder, and tighten wheel cylinder bolts and
8) Install parking brake cable to brake back plate.
9) Install brake shoes, referring to steps 1) and 3) of BRAKE
10) Install brake drum. (Refer to steps 1) to 2) of BRAKE DRUM
11) Refill differential housing with new specified gear oil. Refer to
12) Fill reservoir with brake fluid and bleed brake system. (For
13) Install wheel and tighten wheel nuts to specified torque.
14) Upon completion of all jobs, turn adjuster upward by flat-head
15) Install console box.
16) Check to ensure that brake drum is free from dragging and
17) Check each installed part for oil leakage.
1. Stopper ring
2. Brake back plate
"A": Grease 99000-25010
back plate.
NOTE:
Make sure that old sealant was removed before applying
new one.
"B": Sealant 99000-31110 or 99000-31090
Tightening Torque
(a): 23 N·m (2.3 kg-m,17.0 lb-ft)
brake pipe flare nut (or nuts) to specified torque. (Refer to
steps 1) to 4) of WHEEL CYLINDER INSTALLATION).
SHOE INSTALLATION.
INSTALLATION.
MAINTENANCE SERVICE in Section 7F for refill.
bleeding operation, refer to BLEEDING BRAKES.)
screw driver, depress brake pedal with about 30 kg (66 lbs)
load three to five times so as to obtain proper drum-to-shoe
clearance.
Adjust parking brake cable. (For adjustment, refer to PARK-
ING BRAKE CHECK AND ADJUSTMENT.)
proper braking is obtained. Then remove vehicle from hoist
and perform brake test (foot brake and parking brake).