Suzuki GA413 Service Manual page 712

10B-18 AIR BAG SYSTEM
Table C:
STEP
1 1) Check "AIR BAG" monitor coupler.
2) Is it connected diagnosis switch terminal and
ground terminal in "AIR BAG" monitor coupler
by service wire?
2 1) With ignition switch OFF, disconnect SDM.
2) Measure resistance between "A15" terminal of
SDM connector and body ground.
3) Is resistance 1 W or more?
Fig. for STEP 2
NOTE:
Upon completion of inspection and repair work, perform following items.
1) Reconnect all air bag system components, ensure all components are properly mounted.
2) Repeat AIR BAG DIAGNOSTIC SYSTEM CHECK to confirm that the trouble has been corrected.
ACTION YES
Remove service wire.
Substitute a known-good
SDM and recheck.
Special Tool
(A): 09932-76010
NO
Go to step 2.
Repair short from "V"
wire circuit to ground.