Suzuki GA413 Service Manual page 530

1. Rear end cover
3. B terminal inner nut
2. Insulator
1. IC regulator screws 3. Brush holder screws
2. IC regulator 4. Brush holder assembly
1. Rectifier holder
1. Rear end frame
2. Rotor shaft
DISASSEMBLY
1) Remove B terminal inner nut and insulator.
2) Remove rear end cover.
3) Remove 2 screws and pull out brush holder assembly.
4) Remove 3 screws and IC regulator.
5) Remove brush holder cover from brush holder.
6) Remove rectifier holder.
7) Hold shaft by using hexagonal box wrench and remove pulley
8) Remove 2 rear end frame nuts and bolts.
9) Drive out rear end frame with rotor tapping shaft lightly by us-
10) Separate rear end frame from rotor evenly by using plastic
3. Rear end frame nut
nut, and then pull out pulley.
CAUTION:
D To hold shaft, use hexagonal box. Duodecimal box
may cause slipping and consequential shaft or tool
damage.
D Do not attempt to hold pulley by using vise or pipe
wrench so as not to distort it.
ing plastic hammer.
hammer.
CAUTION:
Do not hit shaft at slip ring side, when separating ro-
tor and rear end frame.
CHARGING SYSTEM 6H-15