Suzuki GA413 Service Manual page 892

NOTE:
For the descriptions (items) not found in this section, refer to the same section of the Service Manual men-
tioned in the FOREWORD of this manual.
1. Pressure tester
2. Radiator
3. Radiator cap/Cap (included in thermostat cap)
SECTION 6B
ENGINE COOLING
MAINTENANCE
COOLING SYSTEM SERVICE
WARNING:
To help avoid danger of being burned, do not remove ra-
diator cap while engine and radiator are still hot.
Scalding fluid and steam can be blown out under pres-
sure if cap is taken off too soon.
Cooling system should be serviced as follows.
1) Check cooling system for leakage or damage.
2) Wash radiator cap and filler neck with clean water by removing
radiator cap when engine is cold.
3) Check coolant for proper level and freeze protection.
4) Using a pressure tester, check system, radiator cap for proper
pressure holding capacity 110 kPa (1.1 kg/cm
placement of cap is required, use proper cap specified for this
vehicle.
NOTE:
After installing radiator cap to radiator, make sure that the
ear of cap lines is parallel to radiator.
5) Tighten hose clamps and inspect all hoses. Replace hoses
whenever cracked, swollen or otherwise deteriorated.
6) Clean frontal area of radiator core.
7) Using a pressure tester, check cap of thermostat cap for proper
pressure holding capacity 110 kPa (1.1 kg/cm
placement of cap is required, use proper cap specified for this
vehicle.
CAUTION:
When removing cap of thermostat cap, drain coolant
from system in advance.
ENGINE COOLING 6B-1
6B
2
, 15.6 psi). If re-
2
, 15.6 psi). If re-