Suzuki GA413 Service Manual page 590

1. Left side bearing
1. Nut
2. Spring balance (1 – 5 or 1 – 10 kg range)
3. Torque wrench
4. Socket with adapter
6) Draw out side pinion shaft, as shown, and remove side pinions,
side gears, spring washers and thrust washers.
Special Tool
(C): 09922-85811
NOTE:
Do not mix up washers. Keep the original position in mind
for installation.
7) Using special tools indicated below, extract left side bearing
from differential case.
Special Tool
(A): 09913-60910
(B): 09913-85230
ADJUSTMENT AND REASSEMBLY
Bevel Pinion and Bearing
To engage bevel pinion and gear correctly, it is prerequired to install
bevel pinion to differential carrier properly by using adjusting shim
as described on following pages. Shown in following page are rela-
tive positions of bevel pinion, differential carrier and mounting
dummy.
1) Install bevel pinion dummy with bearings into differential carrier
and tighten flange nut so that specified bearing preload is ob-
tained.
NOTE:
D This installation requires no spacer or oil seal.
D Before taking measurement with spring balance or
torque wrench, check for rotation by hand and apply
small amount of oil to bearings.
Special Tool
(A): 09922-75222
(B): 09924-36320
Pinion bearing preload
(a): 5.0 – 13.0 kg-cm (4.4 – 11.2 lb-in.)
Starting torque: 1.0 – 2.6 kg (2.3 – 5.7 lb)
DIFFERENTIAL 7F-7