Suzuki GA413 Service Manual page 392

6B-10 ENGINE COOLING
1. Thermostat
2. Intake manifold
INSTALLATION
1) Install thermostat.
2) Install thermostat cap to intake manifold.
3) Install generator adjusting arm reinforcement.
4) Install engine room center member.
5) Fill cooling system (refer to page 6B-6, 6B-7).
6) After installation, check each part for leakage.
WATER PUMP BELT
For removal, installation, inspection or adjustment, refer to "Gener-
ator (Water Pump) Belt" in CHARGING SYSTEM section.