Suzuki GA413 Service Manual page 137

2
3
**1
1. Screw
2. Steering column upper cover
3. Steering column lower cover
1. Contact coil and
combination switch
assembly
2. Connector
1. Contact coil and combination switch assembly
2. To horn and driver air bag (inflator) module
3. To air bag wire harness
1. Seal and lock pin if equipped, remove lock pin after
installing contact coil and combination switch assembly.
2. Contact coil and combination switch assembly
3. Connector
*1
*: Standard screw
**: Tapping screw
2) Remove steering column cover screws (3 pcs).
3) Loosen steering column mounting bolts (Refer to STEERING
COLUMN in this section).
4) Separate upper cover and lower cover, then remove them.
5) If equipped with air bag system, disconnect yellow connector
and horn connector of contact coil from harness.
6) Remove combination switch/contact coil and combination
switch assembly from steering column.
7) Disconnect 3 connectors from combination switch.
INSPECTION
For vehicle with air bag system
Check contact coil and combination switch wire harness for any
signs of scorching, melting or other damage. If it is damaged, re-
place it as an assembly.
INSTALLATION
1) Check to make sure that vehicle's front tires are set at straight-
ahead position and then ignition switch is at "LOCK" position.
2) Connect all connectors that have been disconnected in RE-
MOVAL of COMBINATION SWITCH/CONTACT COIL AND
COMBINATION SWITCH ASSEMBLY in this section.
3) Install combination switch/contact coil and combination switch
assembly to steering column.
NOTE:
For vehicle with air bag system
New contact coil and combination switch assembly is sup-
plied with contact coil set and held at its center position
with a lock pin and seal. Remove this lock pin after instal-
ling contact coil and combination switch assembly to
steering column.
STEERING WHEEL AND COLUMN 3C-9