Suzuki GA413 Service Manual page 640

9-4 BODY SERVICE
1. Bottom channel
1. Sash
2. Glass run
3. Window regulator
4. Door glass
1. Attaching screw
2. Window regulator assembly
1. Window regulator handle
2. Inside door handle
3. Screw
INSPECTION
D Check regulator sliding and rotating parts for greasing.
D Check gear for wear or damage.
D Check links for damage.
INSTALLATION
Reverse removal procedure to install front door glass and window
regulator noting following points.
D When installing glass to bottom channel, coat channel with soap
water and tap it with a plastic hammer.
Glass-fitted position of bottom channel is as shown in the figure.
Length "a": 56.5 – 60.5 mm (2.22 – 2.38 in.)
D Tighten channel attaching screw in alphabetical order as shown
in the figure.
D When installing glass, check that the top part of the glass con-
tacts the glass run evenly and that the glass moves up and down
smoothly.
If the glass is tilted with respect to the glass run, make a fine ad-
justment with the screws in the figure.
D Securely seal door sealing cover with adhesive.
D Install door window regulator handle so that it has a 455 angle
when glass is fully closed.