Suzuki GA413 Service Manual page 646

9-10 BODY SERVICE
1. Bottom channel
1. Attaching nut
2. Window regulator
3. Attaching bolt
1. Window regulator handle
2. Inside door handle
INSTALLATION
Reverse removal procedure to install rear door glass and window
regulator noting following points.
D When installing glass to bottom channel, coat channel with soap
water and tap it with a plastic hammer.
Glass-fitted position of bottom channel is as shown in the figure.
Length "b": 331.5 – 335.5 mm (13.05 – 13.2 in.)
D When installing glass, check that the top part of the glass con-
tacts the glass run evenly and that the glass moves up and down
smoothly.
If the glass is tilted with respect to the glass run, make a fine ad-
justment with the bolts and nuts in the figure.
D Securely seal door sealing cover with adhesive.
D Tighten nuts in alphabetical order shown in the figure.
D Install door window regulator handle so that it has a 455 angle
when glass is fully closed.