Suzuki GA413 Service Manual page 580

7C-8 CLUTCH
INSTALLATION
NOTE:
Before assembling, make sure that flywheel surface and pres-
sure plate surface have been cleaned and dried thoroughly.
1) Install flywheel to crankshaft and tighten bolts to specification.
1. Flywheel
2. Bolt
2) Using special tool, install input shaft bearing to flywheel.
3) Aligning clutch disc to flywheel center by using special tool,
1. Clutch cover
4) Slightly apply grease to input shaft, then join transmission as-
1. Release bearing
2. Clutch release fork
3. Input shaft
Special Tool
(A): 09924-17810
Tightening Torque
.
(a): 78 N m (7.8 kg-m, 56.5 lb-ft)
Special Tool
(B): 09925-98210
install clutch cover and bolts. Then tighten bolts to specification.
NOTE:
D While tightening clutch cover bolts, compress clutch
disc with special tool (C) by hand so that disc centered.
D Tighten cover bolts little by little evenly in diagonal order.
Special Tools
(A): 09924-17810
(C): 09923-36330
Tightening Torque
.
(a): 23 N m (2.3 kg-m, 16.5 lb-ft)
sembly with engine. Refer to "MANUAL TRANSMISSION" sec-
tion for remounting procedure.
"A": Grease 99000-25210
NOTE:
Turn crankshaft with wrench from front while inserting
transmission input shaft to clutch disc until splines mesh.