Suzuki GA413 Service Manual page 219

1. LSPV lever
2. LSPV spring
3) If rear brake pressure is not within specification, adjust it by
3. LSPV stay
4) Disconnect brake pipe (connecting between master cylinder
1. Master cylinder
5) Upon completion of fluid pressure test, bleed brake system and
changing bolt B tightening position as follows.
D If rear brake pressure is higher than specification, move bolt
B (LSPV stay) downward and if it is lower, upward.
D Repeat steps 2) and 3) until rear brake pressure is within
specification.
D After adjustment, be sure to torque nut to specification.
Tightening Torque
(a) : 23 N·m (2.3 kg-m, 17 Ib-ft)
and 4-way cross joint) from master cylinder.
Attach plug (special tool) to master cylinder as shown in left fig-
ure.
Special Tool
(A) : 09956-02210
Depress brake pedal. If rear brake pressure is 95 – 100 kg/cm
when front brake pressure is 100 kg/cm
safe system functions properly.
Front brake
10,000 kPa
2
100 kg/cm
1,422 psi
perform brake test.
BRAKES 5-23
2
, it means that front fail-
Rear brake
9,500 – 10,000 kPa
2
95 – 100 kg/cm
1,350 – 1,422 psi
2