Suzuki GA413 Service Manual page 245

5) Apply thin coat of brake fluid to all around new grommets (
6) Set a new pin in connector hole and drive it in. At this time, make
1. Pin
2. Connector
3. Master cylinder
INSTALLATION
NOTE:
D See NOTE at the beginning of this section.
D Check clearance between booster piston rod and master
D Adjust booster piston rod length with special tool (Refer to
1) Install master cylinder as shown and torque attaching nuts to
2) Attach hydraulic lines and torque flare nuts to specification.
3) Connect reservoir hose.
4) Fill reservoir with specified brake fluid.
5) After installing, check brake pedal play and bleed air from sys-
6) Perform brake test and check each installed part for fluid leak-
1. Reservoir hose
2. Clamp
3. Connector
2pcs.) and install them to cylinder body, then install reservoir.
end of pin and end face margin of connector equal.
cylinder piston (Refer to BRAKE BOOSTER INSPECTION
AND ADJUSTMENT).
BRAKE BOOSTER INSPECTION AND ADJUSTMENT).
specification.
Tightening Torque
(a): 13 N·m (1.3 kg-m, 9.5 lb-ft)
Tightening Torque
(b): 16 N·m 1.6 kg-m, 12.0 lb-ft)
Distance
" a" : 0 mm (0 in.)
b" : 3 - 6 mm (0.12 - 0.23 in.)
"
tem (refer to BRAKE PEDAL PLAY CHECK and BLEEDING
BRAKES).
age.
BRAKES 5-49