Suzuki GA413 Service Manual page 285

1. ABS hydraulic unit/
control module assembly
2. Brake pipe
3. Nut
REMOVAL
1) Disconnect negative cable from battery.
2) Remove cover and disconnect ABS hydraulic unit/control mod-
ule assembly connector.
1. ABS hydraulic
unit / control
module connector
3) Using special tool, disconnect brake pipes from ABS hydraulic
unit/control module assembly and loosen flare nuts as shown
figure.
Special Tool
(A): 09950-78210
NOTE:
Put bleeder plug cap onto pipe to prevent fluid from spil-
ling. Do not allow brake fluid to get on painted surfaces.
4) Remove three nuts and take out ABS hydraulic unit/control
module assembly from bracket.
INSTALLATION
1) Install hydraulic unit by reversing removal procedure.
Tightening Torque
(a): 23 N
(b): 10 N
(c): 16 N
2) Bleed air from brake system referring to "BRAKE" section.
3) Check each installed part for fluid leakage and perform "ABS
Hydraulic Unit Operation Check" procedure in this section.
NOTE:
For new ABS hydraulic unit/control module assembly, if
"ABS Hydraulic Unit Operation Check" procedure has not
been performed, "ABS" warning lamp may flash when igni-
tion switch is turned ON.
ANTILOCK BRAKE SYSTEM (ABS) (OPTIONAL) 5E-31
CAUTION:
D Do not give an impact to hydraulic unit.
D Use care not to allow dust to enter hydraulic unit.
D Do not place hydraulic unit on its side or upside
down. Handling it in inappropriate way will affect its
original performance.
.
m (2.3 kg-m, 16.6 lb-ft)
.
m (1.0 kg-m, 7.5 lb-ft)
.
m (1.6 kg-m, 12.0 lb-ft)