Suzuki GA413 Service Manual page 1043

0B1-8 MAINTENANCE AND LUBRICATION (4WD)
Proper Engine Oil Viscosity Chart
Temperature
Engine oil capacity
About 4.0 liters
Oil pan capacity
(8.5/ 7.0 US/Imp pt.)
About 0.2 liters
Oil filter capacity
(0.4/0.35 US/Imp pt.)
About 0.8 liters
Others
(1.7/1.4 US/Imp pt.)
About 5.0 liters
Total
(10.6/8.8 US/Imp pt.)
1. Full level mark (hole)
2. Low level mark (hole)
5) Tighten oil filter (1) 3/4 turn from the point of contact with the
mounting surface using an oil filter wrench.
Special Tool
(A): 09915-40611
Tightening Torque
.
(b): 14 N m (1.4 kg-m, 10.5 lb-ft)
6) Replenish oil until oil level is brought to FULL level mark on dip-
stick. (oil pan and oil filter capacity). The filler inlet is at the top
of the cylinder head cover.
It is recommended to use engine oil of SE, SF, SG, SH or SJ
grade.
NOTE:
For temperature between –20_C (–4_F) and 30_C (86_F), it
is highly recommended to use SAE 10W – 30 oil.
NOTE:
Engine oil capacity is specified. However, note that the
amount of oil required when actually changing oil may
somewhat differ from the data in the table depending on
various conditions (temperature, viscosity, etc.)
7) Check oil filter and drain plug for oil leakage.
8) Start engine and run it for three minutes. Stop it and wait five min-
utes before checking oil level. Add oil, as necessary, to bring oil
level to FULL level mark on dipstick.
NOTE:
Step 1) – 7) outlined above must be performed with ENGINE
NOT RUNNING. For step 8), be sure to have adequate ven-
tilation while engine is running.