Suzuki GA413 Service Manual page 743

1. Driver air bag (inflator) module
2. Trim cover must face up
3. 185 cm (6 feet) of clearance
1. Trim cover must face up
2. 185 cm (6 feet) of clearance
3. Mounting attachment
4. M8 bolt and nut
5) In case of driver air bag (inflator) module:
i) Clear a space on the ground about 185 cm (6 feet) in diame-
ter where the driver air bag (inflator) module is to be
deployed. A paved, outdoor location where there is no activ-
ity is preferred. If an outdoor location is not available, a space
on the shop floor where there is no activity and sufficient ven-
tilation is recommended.
Ensure no loose or flammable objects are within the deploy-
ment area.
ii) Place the driver air bag (inflator) module, with its vinyl trim
cover facing up, on the ground in the space just cleared.
In case of passenger air bag (inflator) module
i) Clear a space on the ground about 185 cm (6 feet) in diame-
ter where the fixture (special tool) with attached air bag (infla-
tor) module is to be placed for deployment. A paved outdoor
location where there is no activity is preferred. If an outdoor
location is not available, a space on the shop floor where
there is no activity and sufficient ventilation is recom-
mended. Ensure that no loose or flammable objects are with-
in the deployment area.
ii) Place special tool (passenger air bag (inflator) module de-
ployment fixture) on the ground in the space cleared in step
i), if it has not already been placed there.
Special Tool
(B): 09932-75041 or 09932-75040 and 09932-75050
iii) Fill plastic reservoir in fixture (special tool) with water or
sand. This is necessary to provide sufficient stabilization of
the fixture during deployment.
iv) Attach the passenger air bag (inflator) module in the fixture
(special tool) using mounting attachment, hold-down bolts
and nuts and M8 bolts and nuts.
CAUTION:
Be sure to use the following bolt and nut for fixing
passenger air bag (inflator) module to mounting at-
tachment. Size: M8, Strength: 7T
Securely hand-tighten all fastener prior to deployment.
AIR BAG SYSTEM 10B-49