Software Update Procedure - Ricoh B064 Service Manual

Rev. 07/2002

5.4.2 SOFTWARE UPDATE PROCEDURE

GW Controller/BCU Update
⇒
1. Power off the machine (! 1.1.5 Powering Unit Off).
2. Disconnect the ADF plug, remove the rear upper cover ( x2), then remove the
IC card slot cover ( x1).
3. With its A side facing up, insert the IC card into the slot.
4. Switch the machine on.
5. Wait for the update screen to open.
NOTE: 1) In the ROM number displays, the first line is the software number and
the second line is the version number.
2) The left column displays the current software and version numbers of
the software in the machine, and the column on the right displays the
same information for the data on the IC card.
6. Press the appropriate item on the touch-panel.
• For the GW controller, press System (1) and Copy (2) on the touch-panel, or
you can press  or  on the operation panel.
• For the BCU, press Engine (3) on the touch-panel, or you can press  on
the operation panel.
• To update all, press two buttons simultaneously.
7. To start the installation, press Update (#) on the touch panel, or press  on
the operation panel.
8. The installation screen opens. As the installation progresses, the dashes on the
display are replaced by asterisks (****----)
9. When "Update Done" is displayed, switch the machine off and remove the IC
card.
SM
PC Card -> NEW Page 01
ROM: B0655102
System (1)
ROM: 0.4.6
ROM: B0655102
Copy (2)
ROM: 0. 4. 6
ROM: B0655120
Engine (3)
ROM: 2.19
Exit (0)
PC Card -> NEW Page 01
ROM: B0655102
System (1)
ROM: 0.4.6
ROM: B0655102
Copy (2)
ROM: 0. 4. 6
ROM: B0655120
Engine (3)
ROM: 2.19
Verify (./*) Exit (0)
5-11
SOFTWARE UPDATE
NEW: B0655102
NEW: 0.4.6
NEW: B0655102
NEW: 0. 4. 6
NEW: B0655120
NEW: 2.19
B064S501.WMF
NEW: B0655102
NEW: 0.4.6
NEW: B0655102
NEW: 0. 4. 6
NEW: B0655120
NEW: 2.19
Update (#)
B064S502.WMF
B064/B065