Ricoh B064 Service Manual page 920

Firmware History for B064/B065
Supports the new Wireless LAN option released in October '02.
Default setting for DHCP changed to ON.
R9 jams (B478 Finisher) were displayed as R7 jams.
At the completion of Document Box scanning, a message was sometimes displayed
asking the user to remove the paper from the Finisher tray.
SC870 occurs after multiple groups are selected and assigned a number in the address
book programming screen.
SC819 occurs if "Continue to Program" is performed 196 times in the address book
programming screen.
After the main power comes on with the Weekly Timer, and the Access Code screen
prompts the user for code entry, the screen can be cleared by simply opening and
closing the cover.
"Bond Paper" does not appear as a selection for Tray 1 or the LCT in User Tools –
System Settings – Tray Paper Setting.
The machine serial number is not displayed with SC error codes.
Setting range for SP5501: PM Alarm Level corrected from 0-255K to 0-9999K.
SP2912-001 (Drum Reverse Rotation, Rotation Amount) default value changed from 2
3, setting range changed from 0-10
SP2210 (ID Sensor Pattern Interval) default value changed from 10
SP2201-001, 002, 003, 005 (Development Bias Adjustment) maximum setting changed
from 900 800.
SP2931/2/3/4/5/6-001 (Transfer Current On/Off Timing) default value changed from 0
20.
SP2931/2/3/4/5/6-002 (Transfer Current On/Off Timing) default value changed from 0
15.
SP1902-004 (Fusing Web Motor Control, Web Near End Value) default value changed
from 90 80.
Supports the Key Card, when used in combination with GW firmware 1.12.
Changes made to support the Key Card, as per field request:
"Key Counter" changed to "Key Card" in UP Mode display.
•
Use of the Interleaf function is allowed when "Key Card" is selected (SP mode).
•
Automatic jam when counter reaches 0 has been disabled, so that all remaining
•
pages are printed out.
The following 2 selections have been added to SP5113 (Optional Counter Type):
•
11: Exp Key Card (Add)
12: Exp Key Card (Deduct)
Firmware modified so that when "2: Europe" is selected in SP5131 (Paper Size Type
Selection), it is possible to select F-sized originals in User Tools – System Settings –
General Features.
SC990 sometimes occurs if the signal timing during scanning and printing causes a
delay in the scanning process.
1st Mass Production
DESCRIPTION OF MODIFICATION
1-3.
FIRMWARE
LEVEL
100.
Page 3 of 10
G
G
F
F
F
F
F
F
F
F
F
F
F
F
F
F
F
F
F
E