Ricoh B064 Service Manual page 761

FUSING UNIT
3.9 FUSING UNIT
CAUTION
⇒
Power off the machine (
then allow sufficient time for the fusing unit to cool before you remove it
from the machine.
3.9.1 FUSING UNIT
NOTE: Before you begin, spread a mat or some clean paper on the floor where
you intend to set the fusing unit.
B064R501.WMF
Open the front door.
[A]: Knob (
• Insert the tip of a screwdriver into the hole of the shaft to hold it in position
as the knob is turned to remove or install it.
[B]: Inner cover (
• Pull the fusing unit release lever, then pull the unit out on the rail supports.
[C]: Open the exit separation pawl assembly.
[D]: Stopper bracket (
[E]: Fusing unit (
• Support the bottom of the fusing unit with your hand when you remove it.
B064/B065
1.1.5), remove the plug from the power source,
[A]
x1)
x3)
x1)
x2)
[B]
[D]
[C]
3-58
Rev. 07/2002
[E]
B064R502.WMF
SM