Ricoh B064 Service Manual page 352

Rev. 10/2002
SERVICE PROGRAM MODE TABLES
SP Number/Name
6020* ADF Contact Mode In/Out
6105* Staple Position Adjustment
6113* Punch Hole Adjustment
001 2-Hole
002 3-Hole
6116* Staple Limit Counter for Thick
6119* Punch Enabled (Thick Paper)
6120* Staple Jogger Adjustment
001 A3
002 B4
003 A4 T
004 A4 Y
005 B5 T
006 B5 Y
007 DLT
008 LG
009 LT T
010 LT Y
011 Other
B064/B065
Function/[Setting]
If the original is small (B6, A5, HLT), the delay
sensor detects the leading edge of the sheet
and delays the original at the entrance roller
for the prescribed number of pulses to buckle
the leading edge and correct skew.
[0~1/0/1]
0: Delay skew correction only for small
originals
1: Delay skew correction for all originals,
regardless of size. (May reduce the
scanning speed of the ADF)
Adjusts the stapling position in the main scan
direction.
[–3.5~+3.5/0/0.5 mm]
A larger value shifts the stapling position
outward.
Adjusts the punch hole position in the sub-
scan direction for the punch unit with two
punch holes.
[–7.5~+7.5/0/0.5 mm]
A larger value shifts the punch holes towards
the edge of the paper.
Adjusts the punch hole position in the sub-
scan direction for the punch unit with three
punch holes.
[–7.5~+7.5/0/0.5 mm]
A larger value shifts the punch holes towards
the edge of the paper.
Multiply the normal limit by this number to
determine the staple limit number for thick
paper.
[1~3/3/1 sheet]
Allows punching heavier paper, including tab
sheets.
[0~1/0/1]
0: Punching thick paper prohibited
1: Punching thick paper allowed
Allows fine adjustment of the staple unit
jogger fences for different paper sizes.
[0~1.5/0/0.5 mm]
5-72 SM