Table of Contents
Advertisement
30 July, 1999 (Revised)
6.14 SYSTEM AND ELECTRONICS
6.14.1 SOFTWARE UPDATE USING AN IC CARD
Care of the IC Card
• Never insert an IC card with the main power switch set to ON or remove it when
main power is on.
• Do not set the main power switch to OFF during the software installation
process.
• Since the IC card is a precision part, it must not be exposed to high temperature,
humidity, or direct sunlight.
• Never bend, scratch, or apply excessive shock to an IC card.
Upgrading the Main Control Board Software
1. Enter SP7-801 and check the current version of main control board.
2. Turn off the main power switch on the copier.
3. Insert the required IC card as shown in figure.
NOTE: Confirm the direction of IC card.
4. Turn on the main power switch. The system starts from the IC card.
5. Run the main program download function from SP5-827.
6. After confirming the "End" message displayed on the screen, turn off the main
power switch and remove the IC card.
NOTE: Never remove the IC card before turning off the main power switch.
7. Turn on the main power switch again and check the version of main control
board software by SP7-801.
SYSTEM AND ELECTRONICS
[A]
6-97
A269R152.WMF
Advertisement
Table of Contents
