MAIN MACHINE (B064/B065)
Re-installing the Development Unit
[A]
B064I310.WMF
➀
When re-installing the development unit, engage the plate
on the front of the
development unit with the silver pin [A] inside the machine, then slide it to the left
➁
toward the drum.
If the unit is installed correctly, you should see the pin above the plate, and the
plate should be flat against the front of the development unit.
If the development unit will not move past the pin, the couplings are not aligned
correctly at the back of the machine. Turn the gear on the front of the developer
unit until the couplings engage at the rear of the machine.
Before closing the front door, make sure that the pipe line shutter is rotated down
to the open position.
SM
1-13
B064/B065