Ricoh B064 Service Manual page 765

SOFTWARE UPDATE
Forced Update
If the download does not complete normally and you cannot restart the installation
procedure, execute a forced installation.
⇒
1. Power off the machine (
2. Remove the controller cover and set DIP SW1 to ON.
3. Make sure that the IC card is inserted correctly and switch the machine on.
4. Repeat from Step 5 of the previous section.
NOTE: If the IC card of a different machine is used by mistake to start the
installation, the operation panel will return a message: "Download
Error" or "No Matching Data". Then the machine will log SC999.
Stamp Data Update
After the hard disk has been initialized, the preset stamp data must be downloaded
to the hard disk.
⇒
1. Power off the machine (
2. Disconnect the ADF plug, remove the rear upper cover (
IC card slot cover (
3. With the A side facing up, insert the printer IC card into the slot.
4. Switch the machine on.
5. Wait for the update screen to open.
In the lower right corner of the Download Watermark screen, press OK on the
touch panel.
B064/B065
1.1.5 Powering Unit Off).
1.1.5 Powering Unit Off).
x1).
5-12
Rev. 07/2002
x2), then remove the
SM