Download Error Codes - Ricoh B064 Service Manual

4.2.3 DOWNLOAD ERROR CODES

Display
01 Reboot after
card insert E01
↕
Module ID
Card No. xx/xx
02 Download Error E02
Power off/on
03 Download Error E03
Power off/on
04 Download Error E04
Power off/on
05 Download Error E05
Power off/on
19 Download Error E19
Power off/on
20 Down Error E20
Power Off/On
21 Download Error E21
Power Off/On
22 Download Error E22
Module ID
Card No xx/xx
SC991
SM
Details
Controller ROM update error 1
When the update break data is
stored in NVRAM, the break module
information and the decompression
module capable of writing do not
match.
Controller ROM update error 2.
Error occurs during ROM update
program initialization.
Controller ROM update error 3
The ROM for the write operation
does not exist.
Controller ROM update error 4
GZIP data confirmation fails. (CRC
value check)
Controller ROM update error 5
Error occurs when writing to the
device.
Controller ROM update error 6
Schedule data is unclear.
System error 1 (+SC991)
The physical address cannot be
mapped. Software/hardware is
defective
System error 2 (+SC991)
There is not sufficient memory to
download.
System error 3 (+SC991)
Data fails to decompress. Card
defective.
System error 4
"Selfupdate" does not execute.
Software defective.
4-3
PROGRAM DOWNLOAD
Recovery
• Use the correct card
• Cycle the machine
off/on to rewrite
• Cycle the machine
off/on
• Install the missing
ROM DIMM
• Cycle the machine
off/on
• Set DIP SW 1 to ON
and retry
• Replace RAM DIMM
• Replace controller
board
• Cycle the machine
off/on
• Set DIP SW 1 to ON
and retry
• Replace RAM DIMM
• Replace controller
board
• Software defective
• Cycle the machine
off/on and re-try
• Replace controller
board
• Cycle the machine
off/on and re-try.
• Replace RAM
• Replace the
controller board
• Cycle the machine
off/on and re-try.
• Replace card
• Replace controller
board
• Cycle the machine
off/on and re-try
• Set DIP SW 1 to ON
and re-try
• Replace the
controller board
B064/B065