Operation Panel Software Update - Ricoh B064 Service Manual

Rev. 07/2002

Operation Panel Software Update

⇒
1. Power off the machine (! 1.1.5 Powering Unit Off).
2. Disconnect the ADF plug, remove the rear upper cover ( x2), then remove the
IC card slot cover ( x1).
3. With it's A side facing up, put the operation panel IC card into the slot.
4. Switch the machine on.
5. Wait for the update screen to open.
Press "OpePanel.EXP" then press Update (#).
The installation download starts in about 9 seconds.
The operation panel goes off and the Start  LED flashes red during
downloading.
When the download is completed, the Start  LED flashes green.
⇒
6. Power off the machine (! 1.1.5 Powering Unit Off), remove the IC card, then
switch the machine on.
NOTE: 1) During the download, the operation panel switches off and only the Start
key flashes red.
2) You must wait until the Start key stops flashing red and starts flashing
green.
3) If a power failure occurs during downloading, E32 (Reboot After Card
Insert) is logged. Remove the IC card, switch off the machine. Insert the
card again and switch on the machine to restart downloading.
Printer Update
⇒
1. Power off the machine (! 1.1.5 Powering Unit Off).
2. Disconnect the ADF plug, remove the rear upper cover ( x2), then remove the
IC card slot cover ( x1).
3. With its A side facing up, insert the printer IC card into the slot.
4. Switch the machine on.
5. Wait for the update screen to open.
Press "Opt DIMM Prn (1)" then press Update (#).
When "Power Off/On" is displayed, the download is completed.
⇒
6. Power off the machine (! 1.1.5 Powering Unit Off), remove the IC card, then
switch the machine on.
SM 5-13
SOFTWARE UPDATE
B064/B065