Gw Firmware History - Ricoh B064 Service Manual

Firmware History for B064/B065

GW FIRMWARE HISTORY:

B0655102
E
F
G
H
Reserved jobs are sometimes deleted when the current copy job is halted by a jam or
other cause.
The "Load paper" message is not displayed when all feed trays are empty and there is
paper in the Cover Interposer Tray.
If Copy Interrupt is used once an original has been set in the DF, and is then replaced
with an original with (an effectively) different width, the estimated size of the first original
is not cleared.
Pre-stack jams with the B478 Finisher are not displayed.
Image problem occurs when using Magazine Copy together with Margin Adjustment.
The size of the window for User Tools
Current settings appear overlapped with the default settings on the SMC printout if the
report is printed out with proportional font.
If the virtual keyboard is displayed inside User Tools
WEP), and the User Tools key is then pressed to exit User Tools, the keyboard will
appear again when entering System Settings.
If a normal stapling job with limitless paper exit is halted with Copy Interrupt to print out
a center-stapling job (before switching trays), and the original job is then resumed, the
machine will exit the copies directly on top of the interrupt job.
When printing out a job using Slip Sheet and Stapling, the machine will allow the slip
sheets to be stapled even when the slip sheet paper type cannot be stapled by
specification.
SC990 appears when cover sheets are added at the end of a sample copy trial and the
job is initiated.
The "Wireless LAN Signal" (Interface Settings) sometimes does not function.
"DEC" is not displayed for December dates in the SMC logging data.
Titles for group registration/changes and group name changes are not displayed
correctly on the virtual keyboard.
An incorrect number is displayed on the operation panel when SC870 occurs.
SC990 occurs if performing continuous print jobs using the LPR port when network
traffic is high.
Recovery is not possible if the power is turned off during a simultaneous upgrade of the
System and Copier firmware.
The "waiting" display sometimes does not clear when the machine recovers from
Energy Saver Mode.
The "@" and "_" marks have been added to the virtual keyboard so that it is no longer
necessary to use the SHIFT key to make them appear.
Added the names of all SP2901 test patterns.
Software modified to support Punch Units that only allow a certain number of holes to
be punched (units with no hole qty selection).
VERSION
1.11
1.12.2
1.12.3
3.01.2
DESCRIPTION OF MODIFICATION
System Settings
CHECK SUM
B179 1st Mass Production.
66AF August 2002 Production
AFC2 November 2002 Production
242A February 2003 Production
SSID was incorrect.
System Settings
PRODUCTION
FIRMWARE
LEVEL
H
H
H
H
H
H
H
SSID (or
H
H
H
H
H
H
H
H
H
H
H
H
H
H
Page 2 of 10