Selecting The Staple Supply Name - Ricoh B064 Service Manual

Selecting the Staple Supply Name

Enter the SP mode and execute the following information.
5841* Supply Name Setting
005 Staple Std
006 Staple Bind
Enabling Booklet Binding
To enable booklet binding, you must select the 'center stapling' position.
1. Press the User Tools key.
2. Touch "Copier/Document Server Features".
3. Touch the "Input/Output" tab, then locate the "Select Stapling Position" buttons.
4. Touch any one "Stapling Position" button that will not be used and then touch
the center stapling symbol to replace it.
5. Exit the User Tools mode. Specify the number of copies, touch the center
stapling symbol on the operation panel, then start the print job.
These SP adjustments are available but not required at installation.
SP6902 Fold Position
Adjustment
SP6120 Staple Jogger
Adjustment
SM
3000-SHEET FINISHERS (B468/B469)
These names appear when the user presses the Inquiry
button on the initial User Tools screen.
Enter the name of the staples in use for normal stapling
(not booklet stapling). This setting should be done for both
the B468 and B469.
Enter the name of the staples in use for booklet stapling
(saddle-stitching). This setting is required only for the
B468.
Use this SP to fine adjust the fold and staple positions if they
are not aligned correctly. See "5. Service Tables".
Allows fine adjustment of the staple unit jogger fences for
different paper sizes, if required. See "5. Service Tables".
1-33 B064/B065