Ricoh B064 Service Manual page 859

Tech Service Bulletin No. B064/B065 – 018 REISSUE
(3) Loosen screws [B] and [C] and allow the spring to reposition the unit. (See photograph below)
[A]
(4) Tighten screws [B] and [C]. (See photograph on page 1)
3. If neither Item 1 nor Item 2 above apply:
1) Using the following table, check the jam count values. For locations that show frequent occurrences,
replace gears [A] and/or [B] below that contain the arrow shown in the "NG" illustration.
Tray
1st
2nd
3rd
2) Clean the shaft, and then replace the gear(s) as indicated in the table above.
Which gears need to be replaced:
As shown above, replace gears whose cutouts and arrows are in different positions.
Jam 12 Jam 8
Gear A Gear B
Gear A
[B]
[C]
Jam 9 Jam 10
Gear B
Gear A Gear B
Continued....
Page 2 of 4