Bike Settings; Measuring Wheel Size - Polar Electro Vantage M User Manual

If you are pairing a third-party power sensor, please make sure that you have the latest firmware both
in your watch and the sensor. If you have two power transmitters, you need to pair the transmitters one at
a time. After pairing the first transmitter, you can immediately pair the second one. Check the device ID on
the backside of each transmitter to make sure you find the correct transmitters from the list.
1. There are two ways to pair a sensor with your watch:
2. On your watch, go to General Settings > Pair and sync > Pair sensor or other device and
press OK.
3. The watch starts searching for your sensor. Cadence sensor: Rotate the crank a few times to
activate the sensor. The flashing red light in the sensor indicates that the sensor is activated.
Speed sensor: Rotate the wheel a few times to activate the sensor. The flashing red light in the
sensor indicates that the sensor is activated. Third-party power sensor: Rotate the cranks to
wake up the transmitters.
4. Once the sensor is found, the device ID is displayed. Press OK to start pairing.
5. Pairing completed is shown when you are done.
OR
1. On your watch, press BACK to enter the main menu and choose Start training to enter pre-train-
ing mode.
2. The watch starts searching for your sensor. Cadence sensor: Rotate the crank a few times to
activate the sensor. The flashing red light in the sensor indicates that the sensor is activated.
Speed sensor: Rotate the wheel a few times to activate the sensor. The flashing red light in the
sensor indicates that the sensor is activated. Third-party power sensor: Rotate the cranks to
wake up the transmitters.
3. You'll be prompted to pair your watch with the sensor. Accept the pairing request by pressing OK.
4. Pairing completed is shown when you are done.

Bike settings

1. Sensor linked to: is displayed. Choose Bike 1, Bike 2 or Bike 3. Confirm with OK.
2. Set wheel size is displayed if you paired a speed sensor or a power sensor that measures speed.
Set the size and press OK.
3. Crank length: Set the crank length in millimeters. The setting is visible only if you paired a power
sensor.

Measuring wheel size

Wheel size settings are a prerequisite for correct cycling information. There are two ways of determining
the wheel size of your bike:
Method 1
78