04 Reverb & Gate; Reverb - Roland MV-8000 Owner's Manual

04 Reverb & Gate

Reverb

This is a high-quality digital reverb. It is also
equipped with a gate function to cut the reverb sound
as it is produced, providing you with gated reverb,
reverse reverb, ducking reverb, and other particular
effects.
1. Room Size
Value: 5–40 m
Sets the size of the room. For example, the setting
"10m" gives you reverb as it would sound in a single
space 10 meters wide.
2. Time
Value: 0.1–32 sec
Sets the reverb time in seconds.
3. Pre Delay
Value: 0–200 msec
Sets the delay time between the source sound and the
point at which the reverb sound is started. This
indicates distance from the source of the sound.
4. Diffusion
Value: 0–100
Increasing this value intensifies the sense of spatial
width. This is effective when playing back in stereo.
5. Density
Value: 0–100
Increasing this value makes the reverb sound denser.
For hall or garage sounds, make this thinner.
6. Low Damp Freq
Value: 50 Hz–4000 Hz
Sets the upper frequency limit of the range to be
damped by "Low Damp." The Low Damp function
damps the low frequency band of the reverb sound
quicker than other bands, which makes for a clearer
reverb effect.
7. Low Damp Gain
Value: -36 dB–0 dB
Sets the degree of the Low Damp.
8. High Damp Freq
Value: 1 kHz–20 kHz
In the natural world, the high frequencies in
reverberation die out quicker than other bands. High
Damp, by attenuating the higher frequencies first,
makes the reverb sound more natural.
Sets the lower frequency limit of the range to be
dampened.
9. High Damp Gain
Value: 36 dB–0 dB
Sets the degree of the High Damp.
By combining Low Damp and High Damp, you can
indicate the qualities of the room such as surface
material (or the sound absorption properties
thereof.)
10. High Cut Freq
Value: 0.2 kHz–20 kHz
Upper band than this frequency of the reverb sound
are gently cut to make the reverberation more stable.
This does not make time-based changings.
Effect Block
405