Sync Screen - Roland MV-8000 Owner's Manual

SYNC screen

Here you can make synchronization settings.
Explanation of each area
1. MIDI Clock Output
Selects the connector (MIDI OUT A, MIDI OUT B, or
R-BUS) from which MIDI Clock will be transmitted
(output).
Parameters
MIDI OUT A
MIDI OUT B
R-BUS
The R-BUS connector is available if the MV8-OP1
(sold separately) is installed.
2. MMC Mode
Specifies the device that will be remotely controlled
via MMC (MIDI Machine Control).
Value Explanation
The MV-8000 will transmit MMC to
Master
control other connected devices.
Slave (MIDI) The MV-8000 will receive and be
controlled by MMC transmitted by
Slave (R-BUS)
another connected device.
3. MMC Output
Specifies the connector from which MMC will be
output (transmitted) when MMC Mode = Master.
Parameters
MIDI OUT A
MIDI OUT B
R-BUS
The R-BUS connector is available if the MV8-OP1
(sold separately) is installed.
Value
Off, On
Off, On
Off, On
Value
Off, On
Off, On
Off, On
To access this screen
➜ (move the cursor to the upper line of
•
icons) ➜
4. MTC Frame Rate
Specifies the format of the MTC transmitted (output)
by the MV-8000.
Value Explanation
30 frames per second
30
29.97ND 29.97 frames per second, non-drop
29.97D 29.97 frames per second, drop-frame
25 25 frames per second
24 24 frames per second
5. MTC Offset Time
Specifies the time difference between the sequencer
time and the MTC timing when the MV-8000 is
MTC-synchronized from an external device.
Range:
00h00m00s00f~23h59m59s##f
6. MTC Output
Specifies the connector from which MMC will be
output (transmitted) when MMC Mode = Master.
Parameters
MIDI OUT A
MIDI OUT B
R-BUS
7. Remote (MIDI In)
Specifies whether the Start/Stop message (MMC)
received from an external MIDI device will be
controlled the sequencer
Range: Off, On
SONG SETUP
Value
Off, On
Off, On
Off, On
259