Recording Parameter (Audio) Popup - Roland MV-8000 Owner's Manual

SEQUENCE

RECORDING PARAMETER (AUDIO) popup

Here you can set recording parameters for an audio
track.
Explanation of each area
1. Rec Mode (Recording mode)
Specifies how recording will occur.
Value Explanation
Direct Record audio directly from the Input to the
Stereo track (2-channels).
Direct Record audio directly from the Input to the
Mono track (1-channel).
Record the playback timing of audio phrases
triggered from the velocity pads.
Event
Since only timing data will be recorded,
this is a way to conserve the data size
when recording the identical audio
material on the track.
2. Count In
Specifies how recording will start.
Value Explanation
Recording will begin the instant you press
Off
[PLAY]. (There will be no count.)
Recording will begin after a one-measure
1 Meas
count.
Recording will begin after a two-measure
2 Meas
count.
3. Auto Punch In / Auto Punch Out
You can specify two time locations at which
recording will automatically start and stop ("auto
punch").
Parameter
Auto Punch In
Auto Punch Out
You cannot set Auto Punch In to a location after
Auto Punch Out.
214
Value
0000-01-000 ~ (Auto Punch
Out time)
(Auto Punch In time) ~
9999-**-***
To access this screen
➜
•
➜
•
In order to open this popup, you must specify an
audio track as the current track.
4. Metronome Mode
Specifies when the metronome signal will be output.
Value Explanation
Off The metronome will not sound.
The metronome will sound only during
Rec Only
recording.
The metronome will sound during play-
Play&Rec
back and recording.
Always The metronome will always sound.
5. Input Quantize Type
You can apply quantization while you record into the
sequencer when Rec Mode is "Event."
Range: (60),
(320), (480)
6. Level meter
Indicates the input level.
F-buttons
Reset Peak
Clears the indicators of the peak hold in the Level
meters.
Metronome
Displays the METRONOME popup (p. 215).
Close
Closes the RECORDING PARAMETER (AUDIO)
popup (p. 214).
(80), (120), (160), (240),