Making V-Link Settings; V-Link Function Chart - Roland MV-8000 Owner's Manual

Using the MV-8000 with MIDI or V-LINK devices

Making V-LINK settings

1. Press .
The SYSTEM MENU screen (p. 319) will appear.
2. With the cursor located in the upper row of
icons, press
select the V-LINK icon and press
The V-LINK screen (p. 325) will appear.
3.
Specify the MIDI transmit channel and other parameters as desired.
For details on the function of these parameters, refer to V-LINK screen (p. 325).

V-LINK Function chart

When V-LINK function is on, you can use the following functions.
V-LINK function
Changing Clip
Changing Clip Bank
Color (Cr) Control
(Color-difference signal)
Color (Cb) Control
(Color-difference signal)
Brightness Control
Dissolve Time
(Amount time the video
clips overlap)
VFX Control (Visual
effects)
170
(V-Link). Alternatively,
.
Uses
controller
Velocity Pads
[PAD BANKS]
button
Slider 1
Slider 2
Slider 3
Slider 4
Slider 5
Transmitted MIDI message
Program change:
00H~0FH
CC 00 (Bank select):
00H~1FH (Audio track)
00H~05H (MIDI track)
CC 71 (Resonance)
CC 01 (Modulation)
CC 74 (Cutoff)
CC 73 (Attack time)
CC 72 (Release time)
The MV-8000 does not support
the Edirol DV-7PR's Dual
Stream mode.
For the Control Ch parameter,
select the MIDI connector to
which your V-LINK device is
connected.
You can change the
transmitted MIDI message
used by sliders. For details
refer to V-LINK screen (p.
325).
You use [PAD BANK] to
switch banks, a CC 00 message
and Program Change are
successively transmitted when
you strike a velocity pad.
When switching palettes, the
range of selectable banks will
depend on the type of the
current track (audio track or
MIDI track).
Please also read the owner's
manual of the V-LINK device
you are using.