Mastering Tool Kit Edit Screen - Roland MV-8000 Owner's Manual

MASTERING TOOL KIT EDIT screen

Here you can edit all the parameters of the mastering
tool kit.
Explanation of each area (EQ)
Here you can adjust the tonal character.
1. Mastering Tool Kit
Here you can make settings for the mastering effects.
2. Effect block
Shows the internal structure (blocks) of the mastering
tool kit. The block you are currently editing is shown
by the cursor. Use [F1 (Block ▲)] or [F2 (Block ▼)] to
move between blocks.
3. Block name (EQ)
Shows the EQ parameters.
4. Switches
Switches the EQ block on/off.
Range: Off, On
5. G (Gain)
Specifies the amount of boost/cut for each band
(Low/Low-Mid/Hi-Mid/High).
Range: -12~+12 dB
6. F (Frequency)
Specifies the center frequency at which each band
(Low/Low-Mid/Hi-Mid/High) will be boosted or
cut.
Parameter
Low
Low-Mid
Hi-Mid
High
7. Q
Specifies the sharpness of the frequency response
curve for each band (Low/Low-Mid/Hi-Mid/High).
Range
20~2000 Hz
20~8000 Hz
20~8000 Hz
1.4~20.0 kHz
To access this screen
➜
•
8. Type
Specifies the type of equalizer for the Low band and
High band.
Parameter
Shelving
Peaking
* The Q parameter has no effect for bands whose
Type is set to Shelving.
9. Input Gain
Adjusts the overall volume before the signal passes
through the equalizer.
Range: -24~+12 dB
10. Output Gain
Adjusts the overall volume after the signal has passed
through the equalizer.
Range: -24~+12 dB
MASTERING
➜ (select a file) ➜ ➜
Value
Shelving type*
Peaking type
345