V-LINK screen
Here you can make settings for using V-LINK to
perform music and video together.
Explanation of each area
1. Control Ch (Control Channel)
Specifies the MIDI connector and channel used to
control the video clips, color Cb/Cr, brightness, and
video effect switching on a connected V-LINK device.
Range:
A-1~A-16, B-1~B-16, R-1~R-16
R-1~R-16 are MIDI channels transmitted from
R-BUS. In order to use this setting, the MV8-OP1
(sold separately) and DIF-AT24 (sold separately)
must be installed.
2. Color Cr Control
Specifies the control change number used to control
the hue of the color difference signal Cr (red).
Range:
Off, CC1, CC5, CC7, CC10, CC11,
CC71, CC72, CC73, CC74, CC91,
CC92, CC93, Channel Aftertouch
3. Color Cb Control
Specifies the control change number used to control
the hue of the color difference signal Cb (blue).
Range:
Off, CC1, CC5, CC7, CC10, CC11,
CC71, CC72, CC73, CC74, CC91,
CC92, CC93, Channel Aftertouch
4. Brightness Control
Specifies the control change number used to control
the brightness of the image.
Range:
Off, CC1, CC5, CC7, CC10, CC11,
CC71, CC72, CC73, CC74, CC91,
CC92, CC93, Channel Aftertouch
To access this screen
➜ (move the cursor to the upper row of
•
icons) ➜
5. Dissolve Time
Specifies the control change number used to control
the switching time between clip images.
Range:
Off, CC1, CC5, CC7, CC10, CC11,
CC71, CC72, CC73, CC74, CC91,
CC92, CC93, Channel Aftertouch
6. VFX Control (Video Effect Control)
Specifies the control change number used to control
video effects.
Range:
Off, CC1, CC5, CC7, CC10, CC11,
CC71, CC72, CC73, CC74, CC91,
CC92, CC93, Channel Aftertouch
7. Local Switch
Specifies whether the MV-8000's internal sound
source will respond to the pads.
Value
Explanation
Striking the pads will not play the inter-
Off
nal sounds. You cannot sequence
recording if turn this parameter off.
Striking the pads will play the internal
On
sounds.
SYSTEM
325