Quick Assign (Patch:divide) Screen - Roland MV-8000 Owner's Manual

SAMPLING

QUICK ASSIGN (PATCH:DIVIDE) screen

When you set the Auto Divide parameter to On, here
you can assign the divided sampled data to a partial
of a patch.
Explanation of each area
1. Sample Name
Displays the name of the sample.
2. Sample Channel
Displays the number of channel of the sample
(Mono/Stereo).
3. Wave window
Displays the beginning of the divided sampled data
(waveform).
4. Pads
Indicates the state of the pads in the current pad
bank.
Indicate Status
A partial is assigned to the pad.
Nothing is assigned.
A partial will assign to the enclosed pad.
5. Part
Specifies the instrument part to which you want to
assign the sampled data.
Range: 1~16
6. Assign To Pad Bank
Specifies the partial (note number) within the
instrument part selected by Part to which the sample
data will be assigned.
Range: 1~6
364
To access this screen
➜
•
to On) ➜
sampling) ➜
F-buttons
Name
Displays the EDIT NAME popup (p. 199), where you
can edit the pad name.
Set All
Assigns the sample to the pad number 1 of the
specified pad banks.
When assigning samples, a confirmation message
will appear if a pad to which a sample is already
assigned would be overwritten.
If the waveform was not divided even though Auto
Divide was on, [F4 (Preview)] (p. 363) will be
displayed.
EXIT
Returns to the SAMPLING / RE-SAMPLING screen
(p. 355) without assigning the sample data to a pad.
➜ (Set the Auto Divide parameter
(start sampling) ➜
(stop