Various Settings; Restoring The Factory Settings (Factory Reset); System Settings - Roland TR-8 Manual

Various Settings
Restoring the Factory Settings (Factory Reset)
----------------------------~
Here's how to return the TR-8 to its factory-set state.
1. While holding down the [CLEAR] button, turn on the power.
The display indicates
"r
Sl: "
and the [START/STOP] button blinks. If you decide to cancel the factory reset,
turn off the power.
2. Press the [START/STOP] button to execute the factory reset.
3. When the display indicatesll(nP,"turn the TR-8's power off, then on again.
System Setting s
1. While holding down the [PTN SELECT] button, turn on the power.
The [START/STOP] button blinks. If you decide not to make settings, turn off the power.
2. Use the [TEMPO] knob and the pads to change the settings.
Parameter Controller Explanation
OFF, [
:-r
:5
Specifies the MIDI transmit/receive channel.
MIDI [TEMPO]
The display indicates the channel. (default: [
:0)
channel knob
MIDI messages of all channels are received.
Onn
(OMNI)
The MIDI transm it channel will be 10.
If MIDI clock is being input to the MIDI IN connector or the USB
port, the TR-8's tempo will automatically synchronize to MIDI
Lit (AUTO)
clock (default).
*
If MIDI clock is being simultaneously input from the MIDI
MIDI
clock source
[1] IN connector and from the USB port, the USB port takes
priority.
The TR-8 operates at the tempo specified on the unit itself.
Unlit (INTERNAL) Choose
the "INTERNAL" setting if you don't want to synchronize
to an external device.
I
Lit (ON)
Specifies whether data received from the MIDI IN connector will
MIDI through [2]
Unlit (OFF)
be retransmitted from the MIDI OUT connector (ON: default) or
will not be retransmitted (OFF).
BOOST mode
[3]
Lit (ON)
Boosts the output level of the MIX OUT jacks.
Unlit (OFF)
EXTERNAL IN
[4]
Lit (STEREO)
Specifies whether the audio input from the EXTERNAL INjacks
select
Unlit (MONO)
will be stereo (default setting) or mono x 2.
ASSIGNABLE
Hold down variation [A]
If the INST select button or the EXTERNAL IN section's [STEP]
OUTA button is lit, that instrument is output to ASSIGNABLE OUT A.
ASSIGNABLE
Hold down variation [B]
If the INST select button or the EXTERNAL IN section's [STEP]
OUTB button is lit, that instrument is output to ASSIGNABLE OUT B
Screen-saver
Hold down [TAP] and turn
Specifies the time until the screen saver is shown. If this is
DFF,
the [TEMPO] knob
the screen saver is not shown. (default:
5
min)
Lit (PAD)
Each time you press the pad, the setting is switched in the order
PROGRAMMING
of Strong
->
Weak
->
Off.
MODE
[TR-REC]
By holding down the INST select button and pressing a pad,
Unlit (INST)
[you can enter a weak note (default value).
EFFECT MODE
[KIT]
Lit (KIT) The effect type is saved in the kit.
Unlit (SYSTEM) All kits use the same effect type (default value).
3. Press the [START/STOP] button to save the settings.
The settings are saved, and the TR-8 restarts.
I
"'