Verifying The Vrf Configuration - Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual

Configuring Multiple VRF

Verifying the VRF Configuration

To display a list of VRF instances configured for the switch, use the show vrf command. For example:
-> show vrf
Virtual Routers
--------------------+-------+-------------------
default
IpOne
IpTwo
IpThree
The VRF CLI context determines which information is displayed using application-specific show
commands. For example, if IpOne is the active VRF context, then only IP interfaces associated with
IpOne are displayed.
-> vrf IpOne
IpOne: -> show ip interface
Total 1 interfaces
Name
--------------------+---------------+---------------+------+-------+--------
Loopback
intfone
IpOne: -> vrf default
-> show ip interface
Total 6 interfaces
Name
--------------------+---------------+---------------+------+-------+--------
EMP
Loopback
vlan 130
vlan 2
vlan-2000
vlan-2100
Note that when the default VRF CLI context is active, the show commands can display specific
information for another instance. This is done by first entering the vrf command followed by the instance
name and then the show command. For example, the following command displays the IP interfaces
configured for IpOne from within the context of the default VRF CLI:
-> vrf IpOne show ip interface
For more information about the displays that result from these commands, see the OmniSwitch AOS
Release 8 CLI Reference Guide.
OmniSwitch AOS Release 8 Network Configuration Guide
Profile Protocols
default BGP PIM VRRP
max RIP
max BGP
low
IP Address Subnet Mask
127.0.0.1 255.0.0.0
200.1.1.1 255.255.255.0
IP Address Subnet Mask
192.168.10.1 255.255.255.0
127.0.0.1 255.0.0.0
192.168.130.161 255.255.255.0
10.255.11.161 255.255.255.0
172.20.0.1 255.255.0.0
172.21.0.1 255.255.0.0
December 2017
Verifying the VRF Configuration
Status Forward Device
UP NO Loopback
DOWN NO vlan 200
Status Forward Device
DOWN NO EMP
UP NO Loopback
DOWN NO vlan 130
UP YES vlan 2
UP YES vlan 2000
UP YES vlan 2100
page 16-18