Configuring Link Fault Propagation - Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual

Configuring Ethernet Ports

Configuring Link Fault Propagation

Configuring LFP requires the following steps:
1
Create an LFP group. This type of group identifies the source ports to monitor and the destination
ports to bring down when all of the source ports go down. To create an LFP group, use the
propagation group
-> link-fault-propagation group 1
2
Associate source ports with the LFP group. To associate source ports to an LFP group, use the
fault-propagation group source
-> link-fault-propagation group 1 source port 1/2-5 2/3
3
Associate destination ports with the LFP group. To associate destination ports with an LFP group,
use the link-fault-propagation group destination
-> link-fault-propagation group 1 destination port 1/5-8 2/3
4
Configure the LFP wait-to-shutdown timer. This timer specifies the amount of time that LFP will
wait before shutting down all the destination ports. To configure this timer value, use the
propagation group wait-to-shutdown
-> link-fault-propagation group 1 wait-to-shutdown 70
Note. Optional. To verify the LFP configuration, use the
For example:
-> show link-fault-propagation group
Group Id : 2
Source Port(s)
Destination Port(s)
Group-Src-Ports Status
Admin Status
Wait To Shutdown
Group Id : 6
Source Port(s)
Destination Port(s)
Group-Src-Ports Status
Admin Status
Wait To Shutdown
-> show link-fault-propagation group 2
Group Id : 2
Source Port(s)
Destination Port(s)
Group-Src-Ports Status
Admin Status
Wait To Shutdown
See the OmniSwitch AOS Release 8 CLI Reference Guide for more information about LFP commands.
OmniSwitch AOS Release 8 Network Configuration Guide
command. For example:
command. For example:
command. For example:
: 0/1-2 1/1-5 1/7,
: 0/3 1/10-13,
: up,
: enable,
: 10
: 1/2 1/6 1/9,
: 1/10-11 1/13,
: down,
: disable,
: 5
: 0/1-2 1/1-5 1/7,
: 0/3 1/10-13,
: up,
: enable,
: 10
command. For example:
show link-fault-propagation group
December 2017
Link Fault Propagation
link-fault-
link-
link-fault-
command.
page 1-25