Modifying The Dynamic Aggregate Group Actor System Id; Modifying The Dynamic Aggregate Group Partner Administrative Key - Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual

Configuring Dynamic Link Aggregation

Modifying the Dynamic Aggregate Group Actor System ID

By default, the dynamic aggregate group actor system ID (MAC address) is 00:00:00:00:00:00. The
following subsections describe how to configure a user-specified value and how to restore the value to its
default value with the
Configuring a Dynamic Aggregate Group Actor System ID
You can configure a user-specified dynamic aggregate group actor system ID by entering linkagg lacp
agg followed by the dynamic aggregate group number, actor system-id, and the user-specified MAC
address (in the hexadecimal format of xx:xx:xx:xx:xx:xx), which is used as the system ID.
For example, to configure the system ID on dynamic aggregate group 4 as 00:20:da:81:d5:b0, enter:
-> linkagg lacp agg 4 actor system-id 00:20:da:81:d5:b0
Restoring the Dynamic Aggregate Group Actor System ID
To remove the user-configured actor switch system ID from the configuration of a dynamic aggregate
group, use the no form of the
followed by the dynamic aggregate group number and actor system-id.
For example, to remove the user-configured system ID from dynamic aggregate group 4, enter:
-> no linkagg lacp agg 4 actor system-id

Modifying the Dynamic Aggregate Group Partner Administrative Key

By default, the dynamic aggregate group partner administrative key (the administrative key of the partner
switch) is 0. The following subsections describe how to configure a user-specified value and how to
restore the value to its default value with the
Configuring a Dynamic Aggregate Group Partner Administrative Key
You can modify the dynamic aggregate group partner administrative key to a value ranging from 0 to
65535 by entering linkagg lacp agg followed by the dynamic aggregate group number, partner admin-
key parameter, and the value for the administrative key.
For example, to set the partner administrative key to 4 on dynamic aggregate group 4, enter:
-> linkagg lacp agg 4 partner admin-key 10
Restoring the Dynamic Aggregate Group Partner Administrative Key
To remove a partner administrative key from the configuration of a dynamic aggregate group, use the no
form of the linkagg lacp agg partner admin-key command by entering no linkagg lacp agg followed by
the dynamic aggregate group number and the partner admin-key parameter.
For example, to remove the user-configured partner administrative key from dynamic aggregate group 4,
enter:
-> no linkagg lacp agg 4 partner admin-key
OmniSwitch AOS Release 8 Network Configuration Guide
linkagg lacp agg actor system-id
linkagg lacp agg actor system-id
linkagg lacp agg partner admin-key
Modifying Dynamic Link Aggregate Group Parameters
command.
command by entering linkagg lacp agg
December 2017
command.
page 9-14