Configuring Lbd; Enabling Lbd; Enabling Remote-Origin Lbd - Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual

Configuring Loopback Detection

Configuring LBD

This section describes how to use the OmniSwitch Command Line Interface (CLI) commands to configure
LBD on a switch.
•
Enable LBD on a switch or port (see
•
Enable remote-origin LBD on a switch or port
•
Configure the LBD transmission timer (see
•
View the LBD statistics on a port (see
•
Recover a port from LBD shutdown (see
•
Configuring Autorecovery-timer (see
page 7-8)
•
Enable LBD on Service Access Interface (see
page 7-9)

Enabling LBD

By default, LBD is disabled on the switch. To enable LBD on a switch, use the
command. For example, the following command enables LBD on a switch:
-> loopback-detection enable
Enabling LBD on a Port
By default, LBD is disabled on all switch ports. To enable LBD on a port, use the
port command. For example, the following command enables LBD in chassis 1 on port 1 of slot 1:
-> loopback-detection port 1/1/1 enable
To enable LBD on multiple ports, specify a range of ports. For example:
-> loopback-detection port 1/1/1-8 enable

Enabling Remote-origin LBD

By default, remote-origin LBD is disabled on the switch. To enable remote-origin LBD on a switch, use
the loopback-detection
command enables remote-origin LBD on a switch:
-> loopback-detection remote-origin enable
Enabling Remote-origin LBD on a port
By default, remote-origin LBD is disabled on all switch ports. To enable remote-origin LBD on a port, use
the loopback-detection port
command enables remote-origin LBD in chassis 3 on port 1 of slot 1:
-> loopback-detection port 3/1/1 remote-origin enable
OmniSwitch AOS Release 8 Network Configuration Guide
"Enabling LBD" on page
"Configuring the LBD Transmission Timer" on page
"Viewing LBD Statistics" on page
"Recovering a Port from LBD Shutdown" on page
"Configuring Autorecovery-timer for LBD shutdown ports" on
command with the remote-origin parameter. For example, the following
command with the remote-origin parameter. For example, the following
7-7)
(see"Enabling Remote-origin LBD" on page
"Enabling LBD on Service-access Interface" on
December 2017
Configuring LBD
7-7)
7-8)
7-8)
7-8)
loopback-detection
loopback-detection
page 7-7