Modifying The Dynamic Aggregate Group Name; Modifying The Dynamic Aggregate Group Administrative State - Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual

Configuring Dynamic Link Aggregation

Modifying the Dynamic Aggregate Group Name

The following subsections describe how to configure and remove a dynamic aggregate group name with
the linkagg lacp agg name
Configuring a Dynamic Aggregate Group name
To configure a dynamic aggregate group name, enter linkagg lacp agg followed by the dynamic aggregate
group number, name, and the user-specified name.
For example, to name dynamic aggregate group 4 "Engineering", enter:
-> linkagg lacp agg 4 name Engineering
Note. If you want to specify spaces within a name, the name must be enclosed in quotes. For example:
-> linkagg lacp agg 4 name "Engineering Lab"
Deleting a Dynamic Aggregate Group Name
To remove a dynamic aggregate group name from the configuration of a switch, use the no form of the
linkagg lacp agg name
number and no name.
For example, to remove any user-configured name from dynamic aggregate group 4, enter:
-> no linkagg lacp agg 4 name

Modifying the Dynamic Aggregate Group Administrative State

By default, the dynamic aggregate group administrative state is enabled. The following subsections
describe how to enable and disable the administrative state of a dynamic aggregate group with the
lacp agg admin-state
Enabling a Dynamic Aggregate Group
To enable the dynamic aggregate group administrative state, enter linkagg lacp agg followed by the
dynamic aggregate group number and admin-state enable. For example, to enable dynamic aggregate
group 4, enter:
-> linkagg lacp agg 4 admin-state enable
Disabling a Dynamic Aggregate Group
To disable the administrative state of a dynamic aggregate group, use the
command by entering linkagg lacp agg followed by the dynamic aggregate group number and admin-
state disable.
For example, to disable dynamic aggregate group 4, enter:
-> linkagg lacp agg 4 admin-state disable
OmniSwitch AOS Release 8 Network Configuration Guide
command.
command by entering linkagg lacp agg followed by the dynamic aggregate group
command.
Modifying Dynamic Link Aggregate Group Parameters
linkagg lacp agg admin-state
December 2017
linkagg
page 9-12