Configuring And Removing An Mld Static Querier - Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual

Configuring IP Multicast Switching
-> no ipv6 multicast static-neighbor vlan 2 port 1/1/13
To reset the SAP port so that it is no longer an MLD static neighbor port, use the no form of the ipv6
multicast static-neighbor command with the service and sap port parameters. For example, the
following command removes SAP port 1/1/23 with designated service 10 as an MLD static neighbor:
-> no ipv6 multicast static-neighbor service 10 sap port 1/1/23

Configuring and Removing an MLD Static Querier

MLD static querier ports receive MLD reports generated on the designated VLAN or SPB service. Unlike
MLD neighbor ports, they do not receive all multicast streams. The following subsections describe how to
configure and remove a static querier by using the
Configuring an MLD Static Querier
To configure a port as an MLD static querier port, use the
the port option. For example, the following command configures port 1/1/13 in VLAN 2 as an MLD static
neighbor:
-> ipv6 multicast static-querier vlan 2 port 1/1/13
To configure an SPB Service Access Point (SAP) as an MLD static querier port, use the ipv6 multicast
static-querier command with the sap port option. For example, the following command configures SAP
port 1/1/23:10 that is bound to SPB service 10 as an MLD static querier:
-> ipv6 multicast static-querier service 10 sap port 1/1/23:10
In this example, 1/1/23:10 serves as a SAP ID, which is comprised of an access port number (1/1/23) and
an encapsulation value (10). SPB service 10 is mapped to SAP ID 1/1/23:10. Traffic received on access
port 1/1/23 that is tagged with VLAN 10 is encapsulated and then forwarded on service 10 through the
SPB network. Refer to
To create an MLD static querier entry on a link aggregate, use the linkagg parameter. For example:
-> ipv6 multicast static-querier vlan 2 linkagg 7
-> ipv6 multicast static-querier service 10 sap linkagg 10:100
Removing an MLD Static Querier
To reset the port so that it is no longer an MLD static querier port, use the no form of the
static-querier command. For example, the following command removes port 1/1/13 with designated
VLAN 2 as an MLD static querier:
-> no ipv6 multicast static-querier vlan 2 port 1/1/13
To reset the SAP port so that it is no longer an MLD static querier port, use the no form of the ipv6
multicast static-querier command with the service and sap port parameters. For example, the following
command removes SAP port 1/1/23 with designated service 10 as an MLD static querier:
-> no ipv6 multicast static-querier service 10 sap port 1/1/23
OmniSwitch AOS Release 8 Network Configuration Guide
Chapter 10, "Service Manager Commands,"
ipv6 multicast static-querier
ipv6 multicast static-querier
for more information.
December 2017
Configuring IPMSv6 on a Switch
command.
command with
ipv6 multicast
page 25-31