Relationship To Other Features; Configuring Dynamic Link Aggregate Groups - Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual

Configuring Dynamic Link Aggregation

Relationship to Other Features

Link aggregation groups are supported by other switch software features. For example, you can configure
802.1Q tagging on link aggregation groups in addition to configuring it on individual ports. The following
features have CLI commands or command parameters that support link aggregation:
•
VLANs. For more information on VLANs, see
•
802.1Q. For more information on configuring and monitoring 802.1Q, see
VLANs."
•
Spanning Tree. For more information on Spanning Tree, see
Parameters."
Note. See "Application Examples" on page 9-25

Configuring Dynamic Link Aggregate Groups

This section describes how to use Command Line Interface (CLI) commands to create, modify, and delete
dynamic aggregate groups. See
page 9-8 for more information.
Note. See "Quick Steps for Configuring Dynamic Link Aggregation" on page 9-3
configuring these mandatory parameters.
The OmniSwitch implementation of link aggregation software is preconfigured with the default values for
dynamic aggregate groups and ports shown in the table in
on page 9-2. For most configurations, using only the steps described in
Aggregate Group" on page 9-8
need to modify any of the parameters listed in the table on
Aggregate Group Parameters" on page 9-11
Note. See the "Link Aggregation Commands" chapter in the OmniSwitch AOS Release 8 CLI Reference
Guide for complete documentation of show commands for link aggregation.
OmniSwitch AOS Release 8 Network Configuration Guide
Chapter 4, "Configuring VLANs."
for tutorials on using link aggregation with other features.
"Configuring Mandatory Dynamic Link Aggregate Parameters" on
is necessary to configure a dynamic link aggregate group. However, if you
for more information.
December 2017
Configuring Dynamic Link Aggregate Groups
Chapter 4, "Configuring
Chapter 6, "Configuring Spanning Tree
for a brief tutorial on
"Dynamic Link Aggregation Default Values"
"Creating and Deleting a Dynamic
page 9-2, please see "Modifying Dynamic Link
page 9-7