Enabling And Disabling Udld - Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual

Configuring UDLD
Configuring UDLD
This section describes how to use Command Line Interface (CLI) commands to do the following:
•
"Enabling and Disabling UDLD" on page
•
"Configuring the Operational Mode" on page
•
"Configuring the Probe-Timer" on page
•
"Configuring the Echo-Wait-Timer" on page
•
"Clearing UDLD Statistics" on page
•
"Verifying the UDLD Configuration" on page
Note. See the "UDLD Commands" chapter in the OmniSwitch AOS Release 8 CLI Reference Guide for
complete documentation of UDLD CLI commands.

Enabling and Disabling UDLD

By default, UDLD is disabled on all switch ports. To enable UDLD on a switch, use the
For example, the following command enables UDLD on a switch:
-> udld enable
To disable UDLD on a switch, use the udld command with the disable parameter. For example, the
following command disables UDLD on a switch:
-> udld disable
Enabling UDLD on a Port
By default, UDLD is disabled on all switch ports. To enable UDLD on a port, use the
command. For example, the following command enables UDLD on port 3 of slot 1:
-> udld port 1/3 enable
To enable UDLD on multiple ports, specify a range of ports. For example:
-> udld port 1/6-10 enable
To disable UDLD on a port, use the udld port command with the disable parameter. For example, the
following command disables UDLD on a range of ports:
-> udld port 5/21-24 disable
OmniSwitch AOS Release 8 Network Configuration Guide
2-6.
2-7.
2-7.
2-7.
2-8.
2-8.
December 2017
Configuring UDLD
udld command.
udld port
page 2-6